Initio I/O HIGHWAY User Manual download pdf (Page 52)

initio

2 When prompted to INSTALL HOST BUS ADAPTER DRIVERS, insert the INI-9XXXU/

9XXXUW DRIVER DISK 2

into drive A: press <Enter>.

3 When prompted to INSTALL ANOTHER HBA DISKETTE, press <ENTER> to con-

tinue.

4 Follow the directions on screen until you come to a window titled: Loading Initio INI-

9XXX Host Adapter.

 Select CONTINUE INSTALLATION.

 Select CONTINUE INSTALLATION again.

5 This completes loading the host adapter driver. Follow the on-screen directions to

complete the SCO UnixWare installation. For further information regarding UnixWare

installation, refer to the SCO UnixWare Installation Handbook.

Adding the Initio driver to an existing UnixWare system

1 Once a UnixWare session is established and a command prompt is ready, type (recall

that UnixWare is case sensitive):

 cp /stand/unix /stand/unix.org , press <ENTER>

 pkgadd -d diskette1 , press <ENTER>

2 Select i910u ihv hba from the list of available host drivers, press <ENTER>.

3 If the INI-9XXX is intended to be the bootable host adapter, the next step to updating

the driver will require a revision to the I910u file. These instructions will guide you

through changing the current software settings for UnixWare to establish the INI-9XXX

as the host adapter for your boot device:

 At the system command prompt, type

 cd /etc/conf/sdevice.d

 Use vi or another editor to modify the file I910u by adding a line

 locate the line $version2

 edit the file by adding the line $static immediately following $version2.

 Rebuild the UnixWare kernel by completing the following steps at the command

prompt :

 /etc/conf/bin/idbuild -B <ENTER>

 cp /etc/conf/cf.d/unix /stand/unix <ENTER>

 cd / <ENTER>

 shutdown -g0 ( 0 is Zero ) <ENTER>

 Y <ENTER>

SCO UnixWare Driver Installation

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

No comments

Initio I/O HIGHWAY User Manual Page 52