Initio I/O HIGHWAY User Manual download pdf (Page 43)

initio

Overview

The I/OHIGHWAY OS/2 driver will support OS/2, 3.0 & 4.0. The device driver for OS/2 is

copied from the INI-9XXXU/9XXXUW DRIVER DISK 1 to your hard drive where it is

initialized during boot-up.

The installation of Initio device drivers to support OS/2 include the following software

files and may be found on the INI-9XXXU/9XXXUW DRIVER DISK 1:

\OS2\INI910U. ADD INI-9XXX SCSI Host Adapter OS/2 driver.

\OS2\INI910U.DDP Script file for installing INI910U.ADD

Installation

The INI-9XXX driver developed for OS/2 will be installed on the disk drive used for

system initialization. The driver is loaded during the system boot routine and will remain

resident on the drive. Installation of the drivers can be accomplished by following one

of the procedures listed:

 New OS/2 Installation

 Adding INI-9XXX host adapter to existing OS/2

The steps used to install the Initio drivers have different system requirements that may

affect basic operation if not installed properly. It is strongly suggested that the selected

procedure be read and understood before proceeding. Please read all instructions

carefully.

New OS/2 installation:

These instructions will guide you through the Initio OS/2 device driver and OS/2 installa-

tion at the same time. The program can be installed from floppy diskettes or from CD-

ROM. The OS/2 driver for the INI-9XXX will be found on the INI-9XXXU/9XXXUW DRIVER

DISK 1

. It is important that the INI-9XXX hardware has been installed successfully before

proceeding further.

1 Make a duplicate copy of OS/2 Diskette 1 using a blank diskette and label it as OS/2

Diskette 1 for INI-9XXX.

2 Copy the INI910U.ADD file from the INI-9XXXU/9XXXUW DRIVER DISK 1 (OS/2

subdirectory) to the root directory on the OS/2 diskette 1 for INI-9XXX.

IBM OS/2 Driver Installation

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 61 62

No comments

Initio I/O HIGHWAY User Manual Page 43