Initio I/O HIGHWAY User Manual download pdf (Page 48)

initio

Installing the Initio driver in a new SCO UNIX system

1 Insert the SCO UNIX N1 boot disk into the floppy drive and turn on the system. At the

SCO UNIX boot prompt, type: link < ENTER >.

2 The system will ask you what packages you want linked to the system; type: i91u <

ENTER >. The system at this point will boot into SCO UNIX. Please refer to the SCO

UNIX Documentation for additional information. When prompted by the installation,

insert the INI-9XXXU/9XXXUW DRIVER DISK 2 diskette into your floppy drive; Press <

ENTER >

3 Please refer to the SCO UNIX Documentation for additional information. You have

completed the installation of the SCO UNIX driver.

Adding the Initio driver to an existing SCO UNIX system

1 Insert the INI-9XXXU/9XXXUW DRIVER DISK 2 diskette into your floppy drive.

2 Type: installpkg under the command prompt, <ENTER>

3 The system will ask you what packages you wish to install.

Type: i91u < ENTER >

4 Change the directory and rebuild the UNIX kernel:

 cd /etc/conf/cf.d < ENTER >

 . /link_unix < ENTER >

5 You have completed the link procedure for the Initio device driver. Exit and reboot

the system.

SCO Unix Driver Installation

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 61 62

No comments

Initio I/O HIGHWAY User Manual Page 48